How to create an Arc with three points:

  1. Click on Draw > Arc 3P on the Ribbon.

or

  1. Enter ARC in the command window.
  2. Specify the start point.
  3. Specify a through point.
  4. Specify the end point.


This is how you create an Arc, specifying the center and starting point:

  1. Click on Draw > Arc CS on the Ribbon, to open the submenu.
  2. Select one of the following options from the submenu:
    Center - Start - End: Specify the center, start and end point one after the other.
    Center - Start - Angle: Specify the center, starting point and included angle one after the other.
    Center - Start - Length: Specify the center, starting point and arc length one after the other.


How to create an Arc by specifying the start and end point:

  1. Click on Draw > Arc SE on the Ribbon, to open the submenu.
  2. Select one of the following options from the submenu:
    Start - End - Angle: Specify the start point, end point and included angle one after the other.
    Start - End - Direction: Specify the starting point, the end point and the tangential direction from the starting point one after the other.
    Start - End - Radius: Specify the start point, the end point and the radius of the arc one after the other.